Page 1 of 1
Safety wiring
Posted: Sat Jul 07, 2012 1:29 am
Pretty simple request maybe some one could help with here, has any one got a picture of there safety wired oil filter, an where they attach the wire to? Have been runnin into a small backing off issue with mine an know the basics of doing it, just looking for a visual aide!!
And any info for a dre drilled drain plug would be good, I don't want a cheap quality one.
And any info for a dre drilled drain plug would be good, I don't want a cheap quality one.
Re: Safety wiring
Posted: Mon Jul 09, 2012 4:02 pm
The most common method is to put a hose clamp of sufficient size on the filter and safety wire the clamp to the motor. Some folks drill a small hole in the skirt in the motor that surrounds the filer opening.
Cheers
Cheers
Re: Safety wiring
Posted: Mon Jul 09, 2012 5:47 pm
Drilling the motor is not on the top of my list of things to do. I would rather drill a bolt close to filter. As for the gear clamp on the filter that was the route chosen in the first place, unless I get my hands on a k & n filter
Re: Safety wiring
Posted: Tue Jul 10, 2012 8:45 pm
K&N oil filters have a weld nut with a pre drilled hole. Then just drill a close by bolt and you're done.
Re: Safety wiring
Posted: Wed Jul 11, 2012 12:16 am
Exactly the reason I wana find them. But that's the issue, finding one in Ontario, no one seems to have them unless someone has a line on them somewhere?!?!?
Re: Safety wiring
Posted: Wed Jul 11, 2012 11:58 am
Hello ,
G.P.Bikes carries K&N filters,I believe Royal carries them as well.
Tnxs. Eric
G.P.Bikes carries K&N filters,I believe Royal carries them as well.
Tnxs. Eric
Re: Safety wiring
Posted: Wed Jul 11, 2012 9:53 pm
Re: Safety wiring
Posted: Thu Jul 12, 2012 12:31 pm
Hello,
In Whitby,Royal and G.P. are on the same street Champlain Blvd.,just off of the 401 at Thickson rd.
Tnxs. Eric
In Whitby,Royal and G.P. are on the same street Champlain Blvd.,just off of the 401 at Thickson rd.
Tnxs. Eric
Re: Safety wiring
Posted: Thu Jul 12, 2012 9:18 pm