Anyone know anyone/shop that will make a one-off carbon fiber piece? Price not much an issue.

What kind of part you want to make ? I have done one-off for myself on my 996.

Would you provide the part that needs to be copied or does the positive need to be made too?

I believe Paul Huit (Pro-6) does make carbon fiber parts too, not sure about one-off though.

Let me know,

Alexis.

I need a heat-shield made up. Very simple I think. Basically about 1 sq. ft, shaped, with a 90 degree angle mounting 'ledge' at the front. I could do the final shaping myself if I had a rough piece with that 90 degree bit.

If you send me the exact dimensions and a quick drawing, I believe I can do that. When do you need that for, I will be pretty busy myself rebuilding my engine and making my fairings, but if it is not that urgent, I can be your man.

FYI, it would be vacuum bagged only, I obviously don't have an autoclave and don't use pre-preg.

Let me know (send me a PM)

Alexis.

Ken,
I may have a line on two local guys. Give me a call.
Bentley